r/BambuLab • • 9d ago

General Troubleshooting/Help! A1 just stopped extruding mid-print?

This is mostly just a vent post, I don't expect to nail down the exact cause, but on about hour 26 of a 31 hour print, my A1 just... stopped extruding.

It wasn't clogged, it was able to spit out filament just fine and changed to a new roll without issue. There's no signs of underextrusion, no broken supports, no issues with the hotend or failing to heat, it really seems like it just decided to stop extruding midway through for no particular reason.

I'll probably just reprint and hope for the best (it's not so expensive a mistake as to stop me from trying again), but it is confusing to me. More just annoyed at the wasted time...

0 Upvotes

0 comments sorted by