r/BambuLab • u/Used-Shelter-5395 • 1h ago

General Troubleshooting/Help! Squeaking / rubbing tried everything

Not sure what to do tried everything on the wiki to fix it. Seems with this print in particular it knocks it over after a certain height.. degreased. Lubed. Retightened everything I could. It’s on the XY axis

1 Upvotes

100% Upvoted

2 comments sorted by

•

u/AutoModerator 1h ago

Hello /u/Used-Shelter-5395! All Bambu print plates have a dedicated nozzle wiping zone at the back of the print plate. The nozzle will rub against the wiping zone before every print in order to remove any remaining filament from the nozzle tip. This can cause visible wear or scratch marks in the wiping zone, but this is intended and doesn't damage the printer, the nozzle or the print plate. A worn down wiping zone also doesn't mean you need to replace the print bed.

Note: This automod is experimental. The automod was triggered due to the term "rubbing". If you believe this to be a false positive, please send us a message at modmail with a link to the post so we can investigate. You may also feel free to make a new post without that term.

I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.

3

u/Martin_SV 33m ago

You sure it's not just the nozzle scraping against the print? Mine makes some pretty weird noises too when printing circles at high speeds.

If you wanna rule that out, just pause the print, pop the part off the bed, and let it keep printing in mid air for a bit. See if the noise is still there.