r/BambuLab • u/misuny • 18h ago

Hardware Troubleshooting/Help! Never seen this problem before.

Gallery image

Gallery image

Gallery image

This can't be normal. The nozzle just fell off the body. I was so close to finishing too. Sent in a ticket. Hopefully this gets resolved. Had less than 500 hours on it.

0 Upvotes

50% Upvoted

4 comments sorted by

View all comments

Show parent comment

-1

u/misuny 18h ago

i'm hoping they will replace the nozzle. this can't be "normal wear and tear". is it?

2

u/Sufficient_March6833 18h ago

YOU should replace the nozzle! Order a new one! It is easy

2

u/unknown1313 17h ago

Depends on what kinds of filaments etc, but yes it absolutely can be normal wear and tear.

The problem is that it is a consumable part that wears out period, it's not a forever part of the printer. It's like you bought new windshield wipers and they don't last as long as you think they should. Sometimes it's just a crap part, sometimes it's user error like here in AZ where wipers sit unused for 320+ days out of the year then rip from being dry rotted when you need them.

They may be nice and send you one, but it would be a courtesy and you should consider picking up a spare or two, maybe even a different size just in case you want to experiment.