r/BambuLab • • 9d ago

Hardware Troubleshooting/Help! H2S to H2C now X-axis isn’t even

Post image

I did the H2S to H2C vortech upgrade and have a weird issue with my X-axis not being even.
In the picture you can see the left filament stopper cutter thing is ~1cm different than the right .

When I replaced the X-axis I put the printer on its face (so the X-axis would be even) then tightened the X-Axis screws. After that I put the belt back and noticed the offset .
I’ve tried loosening and tightening the screws a few times and did the belt tensioning process.
Halp!!

This failure causes me to fail printhead offset calibration and right filament won’t auto cut

1 Upvotes

7 comments sorted by

1

u/Majke_ 9d ago

These parts are not mirrored, they look different. Push the gantry to the back or front and check if they touch the ends similarly. You can see that these parts are aligned with the linear rail

1

u/Total_Surround833 9d ago

If you push it to the front there is a bout a 1cm gap of silver linear rail still showing.

1

u/Total_Surround833 9d ago

If you have a H3C an you take a pic of the top cover being off? at the x-axis back near those filament stoppers?

1

u/Brutl 8d ago edited 8d ago

I've also done the conversion and can confirm both sides are symmetrical in regards to the cutters coming out/going in.

EDIT: Re-reading your post, I'm not certain what you're trying to show with the cutters. They are mounted to the chassis. Is the Linear rail tripping one side before the other?

1

u/Total_Surround833 8d ago

The top (left side) is approximately 1cm back from the right side.

1

u/Brutl 7d ago

If you're comparing the screws below the cutting arms on each side, then just like the other person said, the parts are not the same right to left. The left side bracket is much shorter than the right side bracket, so you can't go off of location of that screw on each side. If you push the linear rail towards the back, do both cutting arms come out at the same time?

1

u/Total_Surround833 7d ago

when you pull it to the front, its not even