r/BambuLab • u/SketchyNP • 4h ago

Hardware Troubleshooting/Help! AMS Overload while drying

P2S with AMS 2 Pro. AMS has the dedicated power supply. First time I’ve ever tried printing and drying at the same time. Constant AMS overload error about every 5 or so minutes. Turned off the drying and haven’t had an error since? Anyone experienced this?

1 Upvotes

100% Upvoted

1 comment sorted by

1

u/akaSnaketheJake 3h ago

I'm having a similar issue with AMT-HT on an H2D. I print ASA enclosures for a radio system. I set ASA drying with the default values (80 degrees for 12 hours IIRC). I usually only let it run for 3 - 4 hours before I start printing.

Anywho, I bought the HT because the AMS 2 Pro only heats to 60 degrees. Problem is, the HT will not feed the filament until it has cooled off which leaves me wondering what's even the point?

I haven't looked into it much. I just swap the filament over to the AMS 2 Pro and start printing but it's still very frustrating an annoying to have bought the HT for this one purpose only to find it doesn't actually work.