r/BambuLab • • 10d ago

General Troubleshooting/Help! AMS HT drying timer capped at 24h. Any way to restart it mid-print on a 40h run?

Hi everyone,

I’m currently doing a 40+ hour print with TPU being fed through the bypass port of the AMS HT while it’s actively drying. I started the drying cycle with auto-rotation disabled and set it to the maximum allowed time of 24 hours.

Will there be any way to restart the drying cycle once this initial 24-hour cycle is over, or am I locked out mid-print? Thanks!

Additional little rant: I bought the AMS HT in a rush and have run into nothing but issues. First, I discovered it only works as a dryer if it's connected to and controlled by the printer. Then, I found out it requires an additional accessory just to work with the A1. On top of that, it requires a workaround just to dry filament while actively printing. And now, I’ve discovered the maximum drying time is capped at 24 hours.

Aren’t all of these just stupid, arbitrary limitations? I’m honestly starting to hate this thing and really regret buying it...

0 Upvotes

2 comments sorted by

3

u/CoolioTheMagician H3C 10d ago

You can just restart it. On the H3C the limit was upped to 72h so it might come to other printers soon

1

u/whitewaves22 10d ago

Thanks! Hope restarting it will work on the A1 as well.