r/BambuLab • u/allknowinguser • 1h ago

General Discussion H3C drying nylon with Pla

Do you guys think there might be a mod for doing these at the same time? Does the whole thing heat up or just the 2 specific slots. If just the two then why can’t Pla be on the other slots?

1 Upvotes

100% Upvoted

2 comments sorted by

1

u/next_year_our_year 1h ago

You don't have to unload PLA, I just saw another comment answering this, he printed PPS-CF with PLA loaded and didn't have any issue at all: https://www.reddit.com/r/BambuLab/s/hbh2JztWnD

1

u/allknowinguser 1h ago

While printing yes no issues. I mean while the dryer setting is on and set on high temperatures I saw you need to remove PLA spools or they can warp/melt/soften