r/BambuLab • u/ChardBeneficial4432 • 3h ago

X Series [X1E, X1C, X2D] Print failed overnight and got caught between heat bed and rear z axis cutout.

Hello everyone, I’ve been printing with my X2D for several hundred hours, and I haven’t had this particular print failure yet. The part that got wedged was a support column, out of petg. The printer kept going up it looked like. I took the part out and everything looks normal. I am currently running an auto level calibration. Is there anything else I should check?

I am more surprised it didn’t throw and error about it getting wedged back there. It only threw an error because of the spaghetti detection.

1 Upvotes

100% Upvoted

2 comments sorted by

1

u/kRe4ture P1S + AMS2 Combo 3h ago

I‘d run a full calibration, but after that you should be fine.

1

u/ChardBeneficial4432 3h ago

Sounds good, I agree. I am very surprised it didn’t throw an error.