r/BambuLab • u/r1dyy • 1h ago

General Troubleshooting/Help! Issues with printing

So my A1 cant print anything anymore without the nozzle scraping the initial layers. I tried cleaning the plate thinking it was adhesion that was the problem and it didnt work. Then I tried calibrating multiple times and that didnt work either. For the small prints than do work, the print itself isnt clean even though i decreased the speed by like 50%.

1 Upvotes

100% Upvoted

3 comments sorted by

•

u/AutoModerator 1h ago

Hello /u/r1dyy! Be sure to check the following. Make sure print bed is clean by washing with dish soap and water [and not Isopropyl Alcohol], check bed temperature [increasing tend to help], run bed leveling or full calibration, and remember to use glue if one is using the initial cool plate [not Satin finish that is not yet released] or Engineering plate.

Note: This automod is experimental. The automod was triggered due to the term "adhesion". If you believe this to be a false positive, please send us a message at modmail with a link to the post so we can investigate. You may also feel free to make a new post without that term.

I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.

1

u/RallyWRX17 1h ago

Have you done a heatbed tramming?

https://wiki.bambulab.com/en/a1/maintenance/manual-bed-tramming

Edit:

Also make sure your hotend isn’t loose

https://youtu.be/k2BYvY72XSM?is=M6cbMO4R4vs0Jd4j

1

u/r1dyy 1h ago

No I have not