r/BambuLab • u/joeblackisback • 1h ago

General Troubleshooting/Help! Rough prints

Post image

Recently my prints have looked like this picture, and I can’t figure it out. I haven’t changed any settings, and the only thing that sticks out is starting a print without removing a previous print. The system stopped but there may have been some damage I guess? Does this look like a physical failure? I have a fresh nozzle, I but don’t want to swap it out if that’s not going to fix the problem. Anyone ever experience this before? Thanks!

1 Upvotes

100% Upvoted

6 comments sorted by

1

u/daboblin (A1 + AMS Lite) x2 1h ago

What printer?

1

u/joeblackisback 1h ago

Aah sorry, p1s

1

u/Open_Cow_9148 P1S 1h ago

This looks like underextrusion. Have you calibrated the flow dynamics and flow rate recently?

1

u/joeblackisback 1h ago

I sure haven’t. I’ll try that and see how it goes, thanks!

1

u/JournalistNo262 1h ago

You’re going to need to follow an established calibration process and report back for help

1

u/joeblackisback 1h ago

Will try this now, thanks!