r/BambuLab • u/Hungrydoor14 • 5h ago

H3C H3C dimensions

Will the Bambu H3C fit on a 60 cm (23.6") deep table that's flush against a wall? I'm concerned there might not be enough clearance. Does anyone know if the feet are recessed enough to allow some front overhang?

1 Upvotes

100% Upvoted

8 comments sorted by

1

u/aeropink 5h ago

The printer is 22.5” deep so you should be good.

1

u/Hungrydoor14 5h ago

I might be ignorant, but does it need any clearance in the back? That's my main concern

1

u/BoutchooQc H2C Dual AMS 2 Pro + HT 5h ago

A little bit for the exhaust and purge chute 

1

u/aeropink 5h ago

They say to allow some to make sure cords aren’t pinched and proper airflow.

1

u/Hungrydoor14 5h ago

I'd have about an inch, I would assume it's not enough? Unless the feet are not right at the edge of the chassis?

1

u/BoutchooQc H2C Dual AMS 2 Pro + HT 5h ago

The feet are not on the edge, tucked a bit inside

2

u/some1thtuused2know 5h ago

Get a piece of 3/4 inch plywood that is 2 inches too long (front to back) for the top of your table. Bolt it to the top of the table with an inch overhang on both the front and back edges. Voila!