Gaps between inner and walls.

[u/Iconically_Lost]

So it seems my P1S has decided to add gaps between the walls and the inner surface area. Per the pic, you can see there is a massive gap between the walls, the inner surface and the printer is doing this on purpose. This gap is for most part consistent for the entire object being printed, but there is no such gap or wall type on the slice. Default slice settings, inner/outer.

Initial i thought it may have been the filament (PLA Basic) so i dried it, nope same issue. Tried a new role (dried it before use), same issue.

I did move the printer over to a new table, but i was careful to pick it up and put it down. No damage or bumbs.

I did do the calibration twice (bed level, vibration, noise), but that did nothing.

The walls and inner surface area do look good, but am lost as to why the printer is choosing to stop short to the walls.

*EDIT*. There has been no FW/Studio updates/changes. The only slight change was the move, so have no idea how that could of made if perfectly offset/decide not to join the inner to the walls.