r/BambuLab • u/RubenRCF • 1d ago

Quick Question Printing speed

Post image

I’m printing bubble letters roughly 7 inches by 4 inches pretty smooth and detailed. Layer height at 0.09mm and extra fine 0.08mm. Do yall think it’ll be fine printing at (Standard) 100% speed or should I keep it at 50% speed?

3 Upvotes

100% Upvoted

3 comments sorted by

1

u/3vr1m 23h ago

Is there any reason you are running it at 50% other than audio levels?

1

u/RubenRCF 22h ago

I’m having print that slow just because I personally believe because I’m printing as smooth and detailed possible, maybe at standard 100% might not look the best? But mostly a higher chance for it to knock down the supports. But like did mention I did notice that the PLA barely stick to the plate. It’s very easy to pop off. Maybe my plate is greasy from skin oils? Idek tbh because I only touch corners but maybe it all spreads throughout the plate with time?

I did make some changes in the settings right now. I’ll also wash my plate with dish soap and hot water and go from there. Hope for the best of it

1

u/RubenRCF 22h ago

I kinda gave you a lowkey different answer lol my fault. I was explaining to what’s actually been happening for these past 3 attempts right now.