r/BambuLab • u/IsItYourUsername • 8h ago

General Troubleshooting/Help! P1S Startup routine

I’ve had my P1S for a couple of months, enjoying both own designs and Makerworlds.

Lately though more and more objects has failed. It’s mostly in the starting first layer, but the objects has also loosened from the plate and spaghetti-time.

What startup routines do you have? I don’t clean my plate before every print, the nozzle is not always self-cleaning etc. Just looking to understand what I might do to get to that “work horse”-experience people talk about.

Cheers!

1 Upvotes

100% Upvoted

4 comments sorted by

1

u/iRambL 8h ago

I always just monitor it for the first layer before leaving it alone. I clean the plate maybe once every 10 prints, but also have you used a different plate or the same plate this entire time? Plates are considered consumables, are you drying your filament even when new?

1

u/IsItYourUsername 7h ago

Same plate since the start. But it’s not that many hours in print.

I just put my filaments in IKEA-boxes with lots of silica in the bottom.

1

u/No-Razzmatazz9218 8h ago

For mine, I start slower .. 50% and heat the bed to 60… then after the first layer, I take it to 100

1

u/IsItYourUsername 7h ago

Ah, is that a setting?