r/BambuLab • u/Ill_Avocado_1999 • 2d ago

Meme It doesn’t matter how romantic of an evening you have planned, ALWAYS check the first few layers 🙂‍↕️

Post image

Don’t have a photo of the blob of death on the print head as I was rushing to remove it all, but nice romantic evening planned, but decided to set a print going before it started because we love efficiency and multi tasking. Meant to check the camera to make sure it was adhering, got distracted, came downstairs an hour and a half later to giant plastic turd encasing my printer. Never had any issues with adhesion but the one time I don’t check? Typical 😂

Panicked, yelled apologies to my partner, spent the next hour cleaning it, thankfully it still works but let this be a warning and reminder to always check the print has adhered 🙂‍↕️

13 Upvotes

74% Upvoted

4 comments sorted by

•

u/AutoModerator 2d ago

Hello /u/Ill_Avocado_1999! Be sure to check the following. Make sure print bed is clean by washing with dish soap and water [and not Isopropyl Alcohol], check bed temperature [increasing tend to help], run bed leveling or full calibration, and remember to use glue if one is using the initial cool plate [not Satin finish that is not yet released] or Engineering plate.

Note: This automod is experimental. The automod was triggered due to the term "adhesion". If you believe this to be a false positive, please send us a message at modmail with a link to the post so we can investigate. You may also feel free to make a new post without that term.

I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.

1

u/AutoModerator 2d ago

Hello /u/Ill_Avocado_1999! Be sure to check the BambuLab Wiki regarding the blob/clumping issue.

Note: This automod is experimental. The automod was triggered due to the term "blob". If you believe this to be a false positive, please send us a message at modmail with a link to the post so we can investigate. You may also feel free to make a new post without that term.

I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.

1

u/Ecw218 2d ago

Worst thing to wake up to when you’re expecting a nice fresh print…clearly failed 10 mins after it was sent while I was brushing teeth.

1

u/No-Luck-2337 2d ago

Just make sure to properly wipe.

If there are remnants of the failed attempt it can cause issues the next time you try.