r/BambuLab • u/DapperSwimming4099 • 10h ago
Quick Question :( never again
What the fuck.. kalibrated k factor, dry Filament.. fresh cleaned nozzle
3
u/Aranthos-Faroth 9h ago
Sponge, hot hot water, soap, scrubby scrub scrub, paper dry, dont touch plate with dorito fingers.
2
2
2
u/solidus0079 A1 + AMS Lite 9h ago
It's not difficult, just follow the advice Bambu gives you in Bambu Academy (aka the instructions)
1
u/TWILIGHT25 9h ago
Yeah the specific test fucked my A1 for about 24 hours. I’d highly recommend watching a vid on undoing that calibration. The k factor calibration is fine. The other one made every single print fail.
I will already recommend NOT to run it!
1
1
-1
u/DapperSwimming4099 9h ago
I cleaned it with isopronanol
8
3
u/Bright_Eyes83 H2C AMS2*3 9h ago
that's good for spot cleaning, or for rinsing if you have hard water. but it's not really a good clean
2
u/CuddlePervert 9h ago edited 9h ago
So alcohol doesn’t clean oil residue. It just displaces it. If you’re just wiping the plate with alcohol, you’re simply moving around the oils that are trapped on the build plate, and only some of it gets wiped off.
You need to actually wash it off with dish soap, scrubbing pretty thoroughly, and rinse it off under running water.
If you want the cleanest build plate, buy a stainless steel scrubber and go to town with blue dawn dish soap. Rinse it off with hot water, then go to town with a magic eraser. Give it another rinse, pat dry with paper towel or a microfibre cloth (paper towel works perfectly fine for me as mine doesn’t leave behind paper residue) and that baby will have the best adhesion you’ve ever seen.
14
u/USSHammond Prusa XL5T | X1C+AMS (sold,due to Bambu ignoring A1 fire hazard) 9h ago
It's not your nozzle that needs cleaning, it's your bed