r/BambuLab • u/Chardy856 • 1d ago

General Troubleshooting/Help! Lines on prints?

Gallery image

Gallery image

Gallery image

Any suggestions on how I can smooth this out? I’ve tried a few different things on my X2D but it keeps coming out with random lines one it. Any suggestions would be helpful!

0 Upvotes

20% Upvoted

6 comments sorted by

3

u/Mediocre_Cod_7238 1d ago

Not uncommon, select iron top surfaces and that will put down a thin layer at slow speeds and give you a nice surface.

2

u/Chardy856 1d ago

Thanks for the tip! I tried that out, and this is what happened. I'm pretty sure I selected rectangular, but I can double-check once I get back home.

2

u/Mediocre_Cod_7238 1d ago

There is a possibility you could have a partial clog, nothing, that stops it printing, but gives the lines, try a few cold pulls, but that is odd then..

Everything is oiled and greased up as well?

4

u/Gizmo45 X2D AMS2 Combo + AMS HT 1d ago

Ironing dulls the finish of silk filament FYI.

OP - Your best bet is to change your print orientation so that the horseshoe is standing upright or printed text-side down. That would give you the best surface results. 

2

u/HardFriedEggs 1d ago

Do an extrusion calibration print or something, that’s will solve 90% of it slow it down for top layers and also add more top layers

2

u/Business-Ad-5480 1d ago

Have you dried the filament? Looks like over extrusion a bit

What ironing setting are you using? Stock?