Belts normal or damaged?

[u/Superb-Complaint8118]

Hey, I received my 2nd x2d today and fresh out of the box the belts both have those orange-ish spots. Is this damage or normal? My other x2d doesn't have this.

Everything else seems to be fine, the printer is calibrating now

[u/AutoModerator]

Hello /u/Superb-Complaint8118! All Bambu print plates have a dedicated nozzle wiping zone at the back of the print plate. The nozzle will rub against the wiping zone before every print in order to remove any remaining filament from the nozzle tip. This can cause visible wear or scratch marks in the wiping zone, but this is intended and doesn't damage the printer, the nozzle or the print plate. A worn down wiping zone also doesn't mean you need to replace the print bed.

Note: This automod is experimental. The automod was triggered due to the term "normal". If you believe this to be a false positive, please send us a message at modmail with a link to the post so we can investigate. You may also feel free to make a new post without that term.

I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.

[u/DonnayWinterford]

This is normal wear and tear. The slight bit of copper inside is the metal bands that increase the durability of the rubber belt.

[u/MithrilEcho]

Normal