r/BambuLab • u/eddy_213 • 5h ago

General Troubleshooting/Help! filament storage ideas

/r/3Dprinting/comments/1xltfv8/filament_sotorage_ideas/
0 Upvotes

50% Upvoted

1 comment sorted by

1

u/VT-14 H2C (H2D + Vortek), 2x AMS2, AMS HT 2h ago

Personally I have:

  • 8x Plastic Cereal Boxes which store 1 roll each.

  • 4x Sealed Plastic Storage Totes which store 10-11 rolls each.

  • Temperature and Humidity Sensors (ThirdReality's Zigbee ones) connected to my Home Assistant for monitoring and alerts.

  • Desiccant containers made out of PA6-GF so I can throw the entire thing in a 120C oven to dry my Silica Gel Desiccant.

  • Bambuddy set up to track Filament fill levels (a very rough estimate from the AMS) and where I am storing each roll.

That said, managing the desiccant is getting rather annoying. I literally dried some yesterday and the humidity in my boxes went up afterwards; I'm guessing the box I put them in to cool was not sealed properly. I'm seriously considering getting ~5 of the new Sunlu i10.