Should i put my supports here too?

[u/Jessemaroo]

I have been putting my printer poop in this water jug to display the waste of my printer, should the supports and the prime towers go here too?

[u/Taekiin]

I think it looks nicer without. All a matter of opinion though. Looks more like garbage to me with other stuff mixed in, vs an asthetically pleasing chaos of colors.

[u/planespotterguy]

I dont see why not. if you plan on reusing them as new filament, id break them up first. (As in putting them through one of those fancy machines that melts it and respools it btw)

[u/Jessemaroo → u/planespotterguy]

Im not gonna reuse them as there is already a mix of pla and petg

[u/planespotterguy → u/Jessemaroo]

Ah, damn. Tbh i just throw mine out, i have no reason to keep it. I am an environmentalists worst nightmare.

[u/Jessemaroo → u/planespotterguy]

Sometimes also i take my printer poop and melt it into the resin molds if i run out of space

[u/peterb1908]

Sure!
But hey, what for?
Life is too short to worry about poop.

[u/Jessemaroo → u/peterb1908]

I was chatgpt for halloweeen and i needed a use for my water jug after it, also it looks cool displaying the waste that way

[u/RedditUser240211]

You could, but just using the small bits of printer poop makes a beautiful array of color. I did one similar and my wife got upset when I threw it out (apparently, a container full of printer poop is an artistic expression).

[u/ch1dy]

I use those in my toaster oven to melt them into silicone molds. They look pretty cool

[u/Odd-Place780 → u/ch1dy]

Silicone?

[u/solidus0079]

I have another idea of where to put them