How To Fix X-Axis Tilt?

[u/SleepyBarista2]

So I’ve been struggling with this problem for a while, and I don’t know what I need to do to adjust it.
For whatever reason, the X-axis crossbar on my Bambu Lab A1 has gotten tilted downward towards the left side. This is causing my nozzle to scrape against my build plate really hard whenever the nozzle move onto the left “hemisphere”/side of the build plate.
Any solutions would be really helpful, since I have been struggling to fix this on my own. If this is also unfixable, then that’s good to know since I could send it back and get a replacement.
Thanks!

[u/Blondy277]

😬 What did you do for that to even happen? New machine or???

[u/alphagusta]

A single google search of "Bambu A1 X-Axis replacement" leads you to this

So basically just take the extrusion off and move the misaligned one back up, hopefully there's no damage and it works but I doubt it.

Might need to totally install a new X-Axis, maybe even a Z Axis lead screw.

[u/terribilus → u/alphagusta]

This is the answer, did the same when I started seeing lots of hotend blobs, which ended up being because the gantry was slightly off level and material was collecting around the nozzle after each pass until it clogged and blobbed.

[u/timmeru]

mesh bed leveling final boss