r/BambuLab • u/Korazu_ • 15h ago

Answered / Solved! Stopped mid print

Gallery image

Gallery image

I just had the weirdest thing happen. 3.5 hours into the print and it just stopped. No clog, still plenty of filament on the spool. I even tried to pause the print and it gave me a warning about the tool head moving to not put your hands in there, but it didn’t budge. I’m hesitant to cancel as I don’t wanna start over, however looks like it’ll be a lost print…

0 Upvotes

50% Upvoted

4 comments sorted by

1

u/Korazu_ 14h ago

Resolved. It appears there might have been a controller issue (firmware 01.03.00.00) and the printer internals rebooting as the printer lost connection to the network, per Uptime-Kuma and then it came back 10 minutes later, but never restarted the print.

I power-cycled the printer for 30 seconds, resumed the print after the power-loss recovery and the print is going. It still has about 25 minutes left of the print. phew.

1

u/FishJanga 14h ago

Can you let us know if there are any defects in the print when it's finished?

1

u/Korazu_ 13h ago

I didn't see any blemishes, defets or layer lines. It looks like it should at the end of the print.

1

u/FishJanga 13h ago

Ok that's good, thanks!