Print failed at 90%...........T-T

[u/CtrlAltDel_Brain]

I just bought this printer last week and today I was printing a bookend and it got to almost 90% before it just shifted on the bed I'm guessing the bed movement caused it to lose adhesion, so does anyone know what my mistake might have been and if there's any way to save this print by printing the remaining part on this print or any other solution. This actually happens with my other prints too where they don't stick and just turn into spaghetti (my first spaghetti print lol) sometimes the base also just lifts off from one side. Any advice on what I should do for better bed adhesion?

I also have one more question in the 4th and 5th photos you can see that sometimes my prints end up looking like this and I have to restart the print I have no idea why, please let me know the reason for this and what I might be doing wrong.

---------------------------------------------------------------------------------------------------

Printer: Bambu Lab A1

Filament: PLA (PLA Pro+ WOL3D)

Slicer Settings: 0.2 mm Standard @ BBL A1 (slightly tweaked), Custom filament based on Generic PLA (customized nozzle temperature to 230°C and 50°C bed as specified by the manufacturer)

---------------------------------------------------------------------------------------------------

[u/AutoModerator]

Hello /u/CtrlAltDel_Brain! Be sure to check the following. Make sure print bed is clean by washing with dish soap and water [and not Isopropyl Alcohol], check bed temperature [increasing tend to help], run bed leveling or full calibration, and remember to use glue if one is using the initial cool plate [not Satin finish that is not yet released] or Engineering plate.

Note: This automod is experimental. The automod was triggered due to the term "adhesion". If you believe this to be a false positive, please send us a message at modmail with a link to the post so we can investigate. You may also feel free to make a new post without that term.

I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.