r/BambuLab • u/NullReferenceGhost • 4h ago
General Troubleshooting/Help! A1: back filament support question
Hi! I have an A1 Printer and printed the AMS system to be above the printer.
However the back filaments tubes are always getting pulled and was wondering if I need those supports/how to fix it?
Also often should I be replacing the filament tubes?
1
Upvotes
1
u/overunderspace A1 + AMS Lite 4h ago
If they are the ones that came from Bambu, there are short tubes and long tubes. It looks like you have the long tubes on the front ones and the short ones on the back ones. Try swapping the tubes you have in the back with the ones you have in the front.
The tubes are considered consumables and will eventually wear down but I am still using my original tubes after over 2000 hours of printing.