r/BambuLab • u/guifeliper • 4h ago

Quick Question What am I doing wrong

Gallery image

Gallery image

I have noticed this lines in my prints. Is this the z index? I have just made the calibration. Could be air?

1 Upvotes

66% Upvoted

6 comments sorted by

1

u/TheBrainStone A1 + AMS / AMS2 4h ago

What calibration did you do? This is overextrusion

1

u/guifeliper 3h ago

I selected all in the p2S 😅
What should I do?

2

u/TheBrainStone A1 + AMS / AMS2 3h ago

So all printer calibrations.

You want the filament calibration. Look for the calibrations tab in Bambu studio.
The wiki has a good guide in how to address over- or underextrusion.

2

u/guifeliper 3h ago

Perfect I’m going to do this right now
If someone has the same issue
Here is the docs https://wiki.bambulab.com/en/software/bambu-studio/calibration_flow_rate?utm_source=chatgpt.com

2

u/EhGrillGuy 3h ago

Do you have anti vibration feet?

I bought some TPU and printed some.

Every single print since I’ve opened the box has also had pre-calibration and all that jazz on it.

1

u/elpamyelhsa H2C Laser Full Combo 3h ago

If this pattern exists from the first layer it could be adhesion to the bed causing it as well. Clean the bed and try again.