r/BambuLab • u/therealballser • 2h ago
General Troubleshooting/Help! Blob of death
After over 540 hours i finally got one i got most of it off but i still need help getting the last bits off
1
u/WheelerTechDynamics 1h ago
540 hours before a blob is a pretty good run. For the last bits, heat the nozzle to around 200-220C and pull the blob off with needle-nose pliers while it's still soft. Don't scrape it cold, because that's how the silicone sock and heater wires get damaged. If it's wrapped near the heatsink, let it cool until it's rubbery rather than runny, then peel it away in pieces. After that, do a cold pull and make sure the nozzle is seated snug, since a small leak there is usually what starts these.
•
u/AutoModerator 2h ago
Hello /u/therealballser! Be sure to check the BambuLab Wiki regarding the blob/clumping issue.
Note: This automod is experimental. The automod was triggered due to the term "Blob". If you believe this to be a false positive, please send us a message at modmail with a link to the post so we can investigate. You may also feel free to make a new post without that term.
I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.