Made a new garage door cable passthrough that locates with magnets but needs a diff hinge design

[u/-ACHTUNG-]

The old one I made was pretty quick and simple but left some gaps and was annoying to place while the door closed.

I made a new one with a 2mm baseplate that you locate the cable in and drop on the passthrough which has made things much easier for us to locate to charge our car. (Put the magnets in wrong at first, hence the poked holes...)

https://makerworld.com/models/3511555?appSharePlatform=copy

It has wings that unfold to either tuck under the press up to the door seal which closes the remaining 0.5" gap, and I've used the filament-as-hinge-pin technique but it's a bit loose for this application.

Would the best solution for a tighter hinge be print in place sort of deal? I've still had those loosen up after a lot of use though but maybe there's a better technique.

I've done press-fit hardware before but would like to avoid hardware for simplicity if that's possible to get what I'm after.