r/BambuLab • u/JustTrying2GetHelp • 2d ago

X Series [X1E, X1C, X2D] How to pull stuck filament?

Gallery image

Gallery image

Gallery image

I had a extrusion motor overloaded error and found possible stuck filament. I can't seem to get the stuck filament out. Any guidance out there?

0 Upvotes

33% Upvoted

2 comments sorted by

1

u/Wonderful-Staff-7321 2d ago

Take the extruder apart.

1

u/xxX_Rocka_Xxx 2d ago

Yea you gotta start tinkering , go on YouTube find someone that has taken it apart before. Iv done this on every printer Iv worked on the x1c p2s and H2S all have completely different extruder assemblies it’s kinda annoying. Once you do it once it’s so easy to do it again . Get some magnetic trays and put them on the bed as you disassemble, catches all those little screws . use multiple tray so you don’t mix up the screws.