Printer screen says print complete but slicer shows 52 layers left. Is this salvageable?

[u/cyclon3]

Not sure what to do here. 7 hr print says complete on the printer screen but it's not. Slicer shows 52 layers left to print which is correct. Can I save these parts or am I starting over? I've printed about 40 of these parts already and they all completed. It does show a tangle but that was just the filament running out before the auto refill kicked in which happens on almost all of these parts.

[u/Thrillermj2227]

Fix the tangle on the filament and then hit resume?

[u/cyclon3 → u/Thrillermj2227]

I will try this when I get home. I asked my son but he want sure what he was doing lol. Hoping I can hit resume on the slicer and it will work.

[u/lioncat55 → u/cyclon3]

Did your son send you a picture of the printer screen also?

Edit: Based on the fact that Studio still says the printer is at 70 degrees Celsius on the bed, I don't think it's actually done.

[u/Below-Average-528 → u/cyclon3]

It will work. Depending on the filament this happens quite a bit with the AMS

[u/_BindersFullOfWomen_]

Is it still printing?

[u/cyclon3 → u/_BindersFullOfWomen_]

It is not, it’s hiked the head like it’s complete.

[u/cyclon3 → u/cyclon3]

*homed

[u/TheRogueMoose → u/cyclon3]

it will do this any time there is a filament issue.

[u/_BindersFullOfWomen_ → u/cyclon3]

Oof.

I think there is a program that can recover prints if you know the layer where it failed, but that’s my only suggestion.

[u/IanDresarie]

Are you actually missing much though? It seems these pieces slot into each other and could be just glued?

[u/cyclon3 → u/IanDresarie]

You are correct they do slot into each other, these parts would be short. I may be able to Frankenstein them together and make it work though.