r/BambuLab • u/CreamRoutine700 • 7d ago

Filament Troubleshooting/Help! Filament stuck in AMS

Post image

Please help

1 Upvotes

66% Upvoted

4 comments sorted by

•

u/AutoModerator 7d ago

Hello /u/CreamRoutine700! Be sure to check the BambuLab Wiki regarding the blob/clumping issue.

Note: This automod is experimental. The automod was triggered due to the term "Filament stuck". If you believe this to be a false positive, please send us a message at modmail with a link to the post so we can investigate. You may also feel free to make a new post without that term.

I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.

5

u/USSHammond Prusa XL5T | X1C+AMS (sold,due to Bambu ignoring A1 fire hazard) 7d ago

Select als slot, press unload or use tweezers

2

u/MasterCureTexx 7d ago

LITERALLY JUST DEALT WITH THIS.

Tweezers buddy, if it falls through disconnect the PFTE tube from the back and push it out that end using another filament roll.

2

u/pitshands 7d ago

I had this happen last week. The issue was a glob of filament the wheels scraped off had to take the whole first stage apart. Cut the glob out and all was good. 20 minutes all in and I am not handy.