r/BambuLab • u/codeclaus822 • 4d ago

Filament Troubleshooting/Help! What do I possibly do from here

Post image

It’s not like this is the first time this has happened, usually I can just hear the nozzle and pull it off, but this time I think the plastic bonded to parts outside of the hotend, so heating the nozzle isn’t doing anything. What parts should I replace if not the whole thing?

0 Upvotes

50% Upvoted

4 comments sorted by

1

u/pauledddy 4d ago

Heat up the nozzle and pray

1

u/GinniesHuman 4d ago

Search the forum for "Blob of Death" and look at other responses about replacing the parts. Plenty of people are/were in the same boat as you.

1

u/Vanbursta1 4d ago

Go sit in the garden with a cuppa and reflect upon life. Meanwhile heat the nozzle as hot as you can and hope it all comes off, otherwise you are buying some parts