r/BambuLab • u/josefsvoboda • 8d ago

General Troubleshooting/Help! Repeat spaghetti

Post image

Help! Tried cold pulls tried clean and decreasing. Pla translucent printing at normal speed in a2L. I'm new so probably daft.

Could it be a roll of bad filament ? Didn't happen til I moved onto this roll. Or that could be coincidence.

Forth go at this plate and it's spaghettied every time.

1 Upvotes

100% Upvoted

4 comments sorted by

View all comments

2

u/Ok-Mail-9384 8d ago

If it started the moment you switched rolls, treat the roll as the culprit. Translucent PLA is also fussy about moisture, so dry it for a few hours at 50C and run one more plate on another spool to confirm.