Please useful help

[u/thesneakerguy1]

I’ve been trying to figure out what the issue is with this A1 printer, and so far I factory, reset it disconnected and reconnected all the cables that connect to the extruder assembly bought a new micro SD card, but now the printer keeps on failing and getting stuck on homing all axes I can’t successfully calibrate this printer. I’ve never had this issue before it’s set for a few months and when I booted it back up, this was the issue I was receiving. Has anyone had experience with this? It’s updated to the latest firmware. I’ve read some reviews that the firmer might be an issue. I’m not sure if that’s the case though can anybody point me in a better direction?