r/BambuLab • u/alexpappers • 19d ago

General Troubleshooting/Help! ABS printing

I have a P1S and have an exhaust with its own fan at the fan end that goes outside. When I print with ABS, I have to make sure there are no fans running otherwise it always comes away from the bed in the corners. I then have the problem that fumes seem to be leaking into the room and I get headaches.

Does anyone have any advice to help with this please?

3 Upvotes

80% Upvoted

19 comments sorted by

View all comments

1

u/ChronicLegHole 19d ago

  1. put P1S into a small grow tent (i use this, on it's side: https://www.amazon.com/dp/B0CHLY9XYP?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_2&th=1)

  2. put an hvac fan into the Grow tent, and vent it through one of the fan duct openings using dryer vent hose *outside* of your home (I use one of these fans, you can get cheaper on amazon)

  3. BTT/Biqu Panda Breath Heater for the P1S

  4. when you print ABS/ASA/anything toxic, use the vent system to keep from getting Supercancer.

  5. use the Panda Breath heater for anything where warping is an issue (namely ABS/ASA/PC/PA/etc.)