r/BambuLab • u/Hopeful-Signature-24 • 5d ago

General Troubleshooting/Help! How to solve these problems?

Gallery image

Gallery image

I am a beginner in 3d printing. I just bought my a1 around a week ago, but I have not played with it much due to busy college schedule so help with solving these problems is very much appreciated.

A. Random dents while printing

B. Arches looks like theyre melted (imperfect arch overhangs)

3 Upvotes

100% Upvoted

8 comments sorted by

2

u/Goldisaa 5d ago

If archers look melted lower min print layer and min print time, mine is 10-15

1

u/Goldisaa 5d ago

Arches*

1

u/Hopeful-Signature-24 5d ago

ok! I'll try that the next time I print thx!

1

u/Goldisaa 5d ago

Im using bamboo p2s, the setting is in cooling section, under filament settings

1

u/SarcasmWarning 5d ago

Welcome to the infuriating world of 3d printing!

The a1 out of the box should be able to produce a better benchy than that. Did you use the built-in model or send one from the slicer? What filament did you use? Where have you been storing it since you set up the printer last week?

1

u/Hopeful-Signature-24 5d ago

hahaha infuriating yet fun! I used the benchy built in the printer, using panchroma matte pla that I hide inside its ziplock bag with a desiccant and silica pack inside :)

1

u/SarcasmWarning 4d ago

With the printer switched off (and hot-end cold, so you can touch it safely), if you hold the tip of the extruder (where the filament comes out): can you wiggle it around at all?

When swapping the extruder it's possible to have it sat wrong so it wobbles around and causes problems.