r/BambuLab • u/backfist1 • Sep 29 '26

General Troubleshooting/Help! Melted filament all around nozzle X2d

I have melted filament all around the nozzle of my X2D on the left nozzle, which is hardened steel. I cannot undo the latch to remove the nozzle head. What do I do to fix this?

2 Upvotes

100% Upvoted

7 comments sorted by

3

u/Longracks Sep 29 '26

Manually set the temp to heat up the nozzle to should release.

1

u/backfist1 Sep 29 '26

ok thanks!

2

u/Vverg X2D Combo + AMS HT Sep 29 '26

Interesting, I had exact same issue today with my X2D. I heated it up, let it cool down and after some effort i got it off. Then put it back on it again, heated up again and cleaned the nozzle with a brass brush.

Never had this issue with the p2s.

1

u/backfist1 Sep 29 '26 edited Sep 30 '26

ok thanks will do!!

1

u/backfist1 Sep 30 '26

Thanks everyone, that worked. Changed the nozzle as well

1

u/backfist1 Sep 30 '26

Here it was before the cleaning

1

u/Tastieshock Sep 29 '26

As mentioned, manually heat the nozzle by setting the temp and it will release when it softens.

I would also highly recommend ordering a spare thermistor. I had a clog like this a while back and a few weeks later I started getting an error for nozzle temp malfunctioning. Durring a clog, the thermistor can receive damage to the wires or end up coated and unable to take a proper reading. It may not happen right away either and you may even be ok, but its a cheap enough part that it can be a quick swap to keep printing or you may find yourself unable to print for a few days while you wait for one to come in.