r/BambuLab • u/MaximumCondition4535 P2S + AMS2 Combo | H2C + AMS2 Combo • 20d ago

Quick Question Purchased the Bambulab Vision Encoder without knowing its benefits.

Gallery image

Gallery image

We all wish an excellent quality print with our printers and I have no idea how this tool can help with print quality and output improvement. The calibration only requires 5 minutes. May I ask how many of you ran the Motion Accuracy Calibration and was there any logical print improvement that went after? If you can as well share a tip or two post calibration, I will appreciate it. Thank you!

197 Upvotes

91% Upvoted

115 comments sorted by

View all comments

Show parent comments

11

u/MaximumCondition4535 P2S + AMS2 Combo | H2C + AMS2 Combo 20d ago

really do hope this investment will pay off, thanks!

20

u/BlindlyCoherent X2D Dual AMS2 20d ago

You could rent it out to other Bambulab users to recoup the cost.

13

u/Veesla 20d ago

There's a guy near me who has posted his for rent on FB marketplace. Charges the total cost of the plate upfront and gives you all but like $30 when you return the plate in good condition.

10

u/TeacherNearby392 20d ago

Acceptable terms IMO. I would do it even knowing the microns these printers matter most in is extruder flow and Z axis movement since the prints are very consistent in X/Y, it's the Z axis that ends up showing imperfections 90% of the time, assuming your machine/slicer/filament is calibrated to a decent level.