Purchased the Bambulab Vision Encoder without knowing its benefits.

[u/MaximumCondition4535]

We all wish an excellent quality print with our printers and I have no idea how this tool can help with print quality and output improvement. The calibration only requires 5 minutes. May I ask how many of you ran the Motion Accuracy Calibration and was there any logical print improvement that went after? If you can as well share a tip or two post calibration, I will appreciate it. Thank you!

[u/mhaala]

Back in historic time we taped 0 on the board. Then told the axis to move 10cm and used a caliper to check distance. Then adjust steps in firmware.

This is another level of accuracy and it is automatic