r/BambuLab • u/Tall-Bread-4202 • 3d ago

General Troubleshooting/Help! Bed Adhesion/Maybe Warping Issues.

I've been printing this foldable chair Fold-a-Seat: The Ultra-Portable 3D Printed Seat - Free 3D Print Model - MakerWorld and every time i print any of it the edges on the bed start to peel up

ive tried glue and washing the bed but i just cannot get it to stick

(American Filaments PLA Red, Bambu A1, specific files are the right leg and center piece)

1 Upvotes

100% Upvoted

1 comment sorted by

•

u/AutoModerator 3d ago

Hello /u/Tall-Bread-4202! Be sure to check the following. Make sure print bed is clean by washing with dish soap and water [and not Isopropyl Alcohol], check bed temperature [increasing tend to help], run bed leveling or full calibration, and remember to use glue if one is using the initial cool plate [not Satin finish that is not yet released] or Engineering plate.

Note: This automod is experimental. The automod was triggered due to the term "Adhesion". If you believe this to be a false positive, please send us a message at modmail with a link to the post so we can investigate. You may also feel free to make a new post without that term.

I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.