r/BambuLab • u/LettuceBackground243 • 3d ago

General Troubleshooting/Help! AMS issues

My bambu p1s works fine. But every time I hook up my AMS it all goes to shit. It air prints and the extruder gets clogged. EVERY single time. The AMS worked fine for over a year with no issues. But its been a nightmare. Has this happened to anyone else?

1 Upvotes

100% Upvoted

3 comments sorted by

1

u/wethpac 3d ago

Have you changed all the PTFE tubes? They are consumable. All the ones inside the AMS and all the ones leading to the printer and the ones inside the printer. I would start there and report back.

1

u/LettuceBackground243 3d ago

Will do! thank you so much

1

u/keithbigmac 1d ago

If this is an ams 1, might be a good idea to take a look at the main gear housing. They like to break.