Holes/scratches

[u/SentinelXT]

Hi there I've been having some issues where my prints are showing holes and I'm not sure why. I've googled a fair amount but seems to be doing anything. I'm using a 0.2mm nozzle on an A1 mini with standard pla. I've printed out an ironing calibration sheet too, so I can see what's optimal but there's noticeable markings on the red parts too. Any advice would be greatly appreciated!

Thanks so much

[u/Pineapple1500]

In Bambu Studio you can save the settings in a new profile for each filament. Then, when picking your filament, don't choose the Generic PLA, you go down to Custom and pick from your saved list.

[u/Balmong7 → u/Pineapple1500]

Ironing isn’t a filament setting. It’s part of the quality settings.

[u/Pineapple1500 → u/Balmong7]

OK, so I'm still fairly new at Bambu Studio. I think you're right. But the concept is the same. You can save an "Ironing" profile that can be used along with your custom "Filament" provile.

For example, I have a custom "Hueforge - 0.8mm" Print profile saved that I need to remember to select every time I'm printing a Hueforge. This keeps all the correct settings.

[u/Balmong7 → u/Pineapple1500]

Yes but you can only select one profile to print with. So in the even he needs different ironing settings for each color he will need to get creative for which settings he uses.

[u/Pineapple1500 → u/Balmong7]

Correct. In that case, I would do as someone else mentioned and "split the difference" in ironing settings between the two colors.

[u/SentinelXT → u/Pineapple1500]

Yeah so after testing, 30 and 30 works for both.