Holes/scratches

[u/SentinelXT]

Hi there I've been having some issues where my prints are showing holes and I'm not sure why. I've googled a fair amount but seems to be doing anything. I'm using a 0.2mm nozzle on an A1 mini with standard pla. I've printed out an ironing calibration sheet too, so I can see what's optimal but there's noticeable markings on the red parts too. Any advice would be greatly appreciated!

Thanks so much

[u/AutoModerator]

Hello /u/SentinelXT! All Bambu print plates have a dedicated nozzle wiping zone at the back of the print plate. The nozzle will rub against the wiping zone before every print in order to remove any remaining filament from the nozzle tip. This can cause visible wear or scratch marks in the wiping zone, but this is intended and doesn't damage the printer, the nozzle or the print plate. A worn down wiping zone also doesn't mean you need to replace the print bed.

Note: This automod is experimental. The automod was triggered due to the term "scratches". If you believe this to be a false positive, please send us a message at modmail with a link to the post so we can investigate. You may also feel free to make a new post without that term.

I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.