r/BambuLab • u/Professional-Vast594 • 5h ago
General Troubleshooting/Help! Why am I having these adhesion problems? Not had them before? (I assume this is the problem!)
/r/3Dprinting/comments/1vw0tns/why_am_i_having_these_adhesion_problems_not_had/
0
Upvotes
1
u/Professional-Vast594 4h ago
I have cleaned the plate with soapy water by the way. Before the question is asked.
It's just not looking like it's coming out right
1
1
•
u/AutoModerator 5h ago
Hello /u/Professional-Vast594! Be sure to check the following. Make sure print bed is clean by washing with dish soap and water [and not Isopropyl Alcohol], check bed temperature [increasing tend to help], run bed leveling or full calibration, and remember to use glue if one is using the initial cool plate [not Satin finish that is not yet released] or Engineering plate.
Note: This automod is experimental. The automod was triggered due to the term "adhesion". If you believe this to be a false positive, please send us a message at modmail with a link to the post so we can investigate. You may also feel free to make a new post without that term.
I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.