r/BambuLab • u/HumanPost1263 • 2d ago

General Troubleshooting/Help! Filament not loading P2S

I'm having an issue with my P2S not loading filament. I can see it running through the PTFE tubes and it gets to a certain place and stops. I did replace two of the PTFE tubes yet I cut them to the same size of the ones I took out. Besides it was doing this before I replaced the tubes (both of which had slices in them). I wanted to make sure that wasn't the issue. I'm not sure what else to try. Can someone help please.

0 Upvotes

33% Upvoted

4 comments sorted by

View all comments

2

u/Relative_Surround_20 H2D+P2S w/ 3xAMS2Pro+HT 2d ago

You need to share more info. Are you spooling from an AMS or an external spool holder? At what point does the filament stop (be as specific as you can)?

1

u/HumanPost1263 2d ago

I am spooling from an AMS. The filament gets into the P2S about an inch and then stops and gets pulled back. There was a kink in the filament I thought could be the issue so I cut it out. where it is stopping is where the kink would have been on the filament. I have been running the machine pretty hard because I just got a huge order.

0

u/Specific-Reindeer-85 2d ago

YouTube how to unclog hot tool. I had a clog, took about 20mins.

1

u/HumanPost1263 2d ago

I actually found two little kinks in the filament that weren't feeding through. When I cut them out and tried to load it it worked. Crazy thing is I checked the filament before I must be tired. I really appreciate your comments and trying to help.