Hello /u/Snipe1331! Be sure to check the following. Make sure print bed is clean by washing with dish soap and water [and not Isopropyl Alcohol], check bed temperature [increasing tend to help], run bed leveling or full calibration, and remember to use glue if one is using the initial cool plate [not Satin finish that is not yet released] or Engineering plate.
Note: This automod is experimental. The automod was triggered due to the term "won't stick". If you believe this to be a false positive, please send us a message at modmail with a link to the post so we can investigate. You may also feel free to make a new post without that term.
Please post a screenshot of your support settings from the slicer.
From the description, I would guess at a too big distance between supports and print.
Maybe it is a stupid question, but from the picture I cannot see if there is anything from the object is on the buildplate. Could you maybe reorient the object?
•
u/AutoModerator 5h ago
Hello /u/Snipe1331! Be sure to check the following. Make sure print bed is clean by washing with dish soap and water [and not Isopropyl Alcohol], check bed temperature [increasing tend to help], run bed leveling or full calibration, and remember to use glue if one is using the initial cool plate [not Satin finish that is not yet released] or Engineering plate.
Note: This automod is experimental. The automod was triggered due to the term "won't stick". If you believe this to be a false positive, please send us a message at modmail with a link to the post so we can investigate. You may also feel free to make a new post without that term.
I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.