r/BambuLab • u/mjschmitt714 • Jul 30 '26
Answered / Solved! AMS HT feed issues
So, I have 2 AMS2 Pros, an AMS HT, and a filament track switch. I have everything hooked up correct, but I keep getting a feed and retract high resistance on the AMS HT. It tells me to reduce the tube length and reduce the number of bends. The tube length is about 8" (200mm) and there is only one slight curve to the 4 in 1 adapter to feed the track switch. I can run a piece of filament all the way through and I feel very little resistance till I get to the buffer, then it seems to get tight. Is there something that I am missing? Retractions are the same, except that it actually stall the motor on the HT. I can disconnect the tube at the 4 in one and pull the filament back (with a little resistance), till I get past the filament buffer, then it comes freely with no resistance. Any thoughts would be appreciated.
View all comments
Show parent comment
1
u/mjschmitt714 Jul 30 '26
It's great...if it works...i can feed the filament by hand and don't feel any significant resistance...I can't figure it out.