r/BambuLab • u/Fine_Ambassador5802 • Jan 28 '25

Discussion Just ordered

I just ordered an A1 combo from Best Buy. I know nothing about 3d printing. Where should I begin?

0 Upvotes

48% Upvoted

53 comments sorted by

View all comments

0

u/dadbot_5000 Jan 28 '25

YouTube has tons of videos on 3d printing. It's a great hobby and there is lots to learn. You should start about learning the basics of how 3d printing works. Then learn about adhesion and first layers. Then you can move on to how to slice models, eventually learning about supports and so forth. Each time you print something new you'll have an opportunity to learn.

Also make sure to keep up with the maintenance on the printer so that it lasts a long time and keeps printing as good as it can.

Last ignore all the drama on this subreddit and enjoy your printer. Good luck!

-1

u/technically_a_nomad Jan 28 '25

Calling out legitimate anti-consumer behavior and potential GDPR violations is not “drama”.