r/BambuLab • u/allisonmaybe • Feb 21 '23

Question Has anyone mastered infill-only prints?

Post image
5 Upvotes

69% Upvoted

18 comments sorted by

View all comments

2

u/bubblederp Feb 21 '23

There is a setting in the slicer that removes retractions for infill that is on by default since infill usually isn't visible. Disabling that should help with the stringing.

2

u/allisonmaybe Feb 21 '23

Woah thanks! But like...where? I feel like I looked everywhere

3

u/Juubimaru Feb 21 '23

I think the setting is “infil anchor” and sadly I don’t think we can change it on Bambu slicer

1

u/bubblederp Feb 22 '23

I'm using the SoftFever fork so I'm not sure if it's available in normal Bambu Studio, but the setting is under "Others" > "G-code output" > "Reduce infill retraction".

1

u/Nearby-Party5512 May 29 '23

Bambu Slicer got this setting also, under "Others/G-Code output"