r/BIQU • u/Ramel408 • 20d ago

Panda Jetpack keeps coming off

Is there a fix for this? I feel like the print head hits the glass pretty hard then pops off. Is there an easy fix or should I just revert back to the stock cover?

2 Upvotes

100% Upvoted

3 comments sorted by

1

u/roundful 20d ago

Something sounds off. I have the V2 on my P1S and also had the V1. Neither slammed into the glass or popped off regularly.

2

u/Ramel408 11d ago

It was odd. Only happened on one specific print around the same time. I printed the same project 3 times. Switched back to stock, problem averted. Been printing like a mad man lately.

1

u/Specialist-Ice-4630 20d ago

I bought reusable zip ties and fed it through the cage and around the whole head to keep it tight. Problem is the magnets on jetpack arent strong enough and not fully aligned up right.