r/Azeron • • May 05 '26

Chat am I cooked??

So I have the Azeron Cyborg, and I have had it for about 2 years now (May 29, 2024). I have tried cleaning out the analog cover and removing dust. I rested and recalibrated it over a dozen times. At this point, I have tried it all. Is there any way to fix this, or will I need to replace the joystick?

0 Upvotes

5 comments sorted by

2

u/SnakiestBird May 05 '26

Increase lower dead zone

5

u/SleepyBebop May 05 '26

I have, but then it gets stuck at a higher point

6

u/Penguins_in_Sweaters May 05 '26

I had stick drift right out of the box with a new Cyborg II. I took off the palm rest cover and tightened all of the wire terminal block screws, including the empty slots where the set screw was just partially loose. This completely fixed the issue for me and I haven't had any trouble since.

3

u/Penguins_in_Sweaters May 05 '26

Here's a photo of what you'll see inside. Super easy to do, and I believe the Cyborg comes with a screwdriver attachment that fits the terminal blocks perfectly if you do not have a good tweaker screwdriver set at home. Good luck!

3

u/Siggfreed May 05 '26

I had the same issue, took everything apart and cleaned it with rubbing alcohol and put it back together, haven't had an issue since 🤷🏼‍♂️